What to USe to Clean Electrical Connections

Discussion in 'Motorbike Technical Discussion' started by Manjo, Nov 13, 2003.

  1. Manjo

    Manjo Guest

    What do you guys use to clean bullet connectors, connector block individual
    male/female tabs? Some folks have suggested WD-40, and a small wire brush.
    Some of my connectors have thick old dielectric grease that refuses to
    dissolve. Others have road grime caked on.

    TIA for tips, suggestions, comments.
     
    Manjo, Nov 13, 2003
    #1

    1. Advertisements

  2. Manjo

    CBXXX Guest

    Deoxit

    Thanks,Ripper
    We Need DEATH SQUADS in the USA to Get Rid of Terrorists AND Street
    Gangs!
     
    CBXXX, Nov 13, 2003
    #2

    1. Advertisements

  3. Manjo

    Manjo Guest

    Thanks for the tips. I'll go to AutoZone and look for Deoxit and Nu-trol.
    The dielectric grease is covered with grime and junk. I'm concerned that it
    may be loosing it's insulating qualities being so full of junk.
     
    Manjo, Nov 13, 2003
    #3

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. What Other Seat Could I Use On A '72 CB450 With No (or slight) Modifications?

  2. What's the best way to clean a chain ?

  3. Cleaning alloy engine cases...what do you use?

  4. Cleaning visors - what to use?

  5. What synthetic motor oils to use in motorcycles?

  6. engine oil - what type to use

  7. What fuggin' use are Jacket sizes?

  8. What petrol to use

Loading...