Someone wanted one of those turntable mats recently so...

here's a link

http://tinyurl.com/2vs3xh

 

In

""I'm over the moon with your MAT turntable. I can move my Pan-European with
ease. I'm just over 8st and nearly 60 years old!!""

Jeepers does'nt he get blown off the bike over 40mph

 

I had one of those for turning the Tiger in the garage. If you don't
have the bike dead-centre on it the damn thing comes apart. And if you
get *any* grit in it it seizes up (and of course you don't get grit in
garages at all do you?).

OK up to a point but over-rated. Basically two sheets of ply with a
couple of non-slip teflon mats in the sandwich and a teflon bearing
arrangement in the middle. Overpriced for what you get.

Phil.

 

I said before, go into B&Q and look in the section of drawer runners, hinges
etc. They do a lovely flat turntable bearing for about £8. A bit of tin or
ply screwed on and Bob is your Cross Dressing Auntie.

www.diy.com/diy/jsp/bq/nav/nav.jsp?action=detail&fh_secondid=9281456&fh_location=%2f%2fcatalog01%2fen_GB&fh_search=bearing&fh_eds=%c3%9f&fh_refview=search&ts=1192466720744&isSearch=true