Putting a bike in a van

Discussion in 'UK Motorcycles' started by rob2, Sep 8, 2006.

  1. rob2

    rob2 Guest

    What's the best way to get a motorcycle to stay upright and safe in the
    back of a luton van. The vans got a tail lift to the liftings taken
    care of, but i'm clueless as to how to tie it down once inside.

    Its a fazer 600 so has a centerstand if that matters, not sure if the
    van will have a place to tie it to inside as it will be a moving style
    boarded out van. The rest of my belongings will also be in there as I'm
    moving flat. I'm hoping it has the waist height metal tie down points
    that other vans have IIRC, just tie it as best I can through the front
    to each side and the back the same?
     
    rob2, Sep 8, 2006
    #1
    1. Advertisements

  2. rob2

    Pip Guest

    Always use the sidestand - it makes the bike more stable: it can only
    fall one way, then ;-)
    Run the bike in all the way to the front, before you load anything
    else. Take it up to the front left corner at 45degrees and wedge the
    front tyre against the front wall of the van. Settle it onto the
    sidestand, making sure the front wheel is tight against the wall, and
    put it in first gear.

    All you need is one strap then, off the left pillion peg down to the
    floor across the van to the left. Pull that down a bit and your bike
    won't move, especially when you pack the rest of your stuff around it.

    Pivoting a bike on its sidestand on a raised tail lift is an art form,
    mind.
     
    Pip, Sep 8, 2006
    #2
    1. Advertisements

  3. rob2

    antonye Guest

    One of these:
    http://www.on-bike.com/products_bikegrab.htm

    and then some handlebar straps like these:
    http://www.motrax.co.uk/Index_pages/accessories/hdbarstarps.htm

    You don't even need to secure the Bike Grab to the floor,
    just push the bike in and then use the bar straps to hold
    it in place. We put ours on a paddock stand once in the
    grab, but don't bother strapping the back down.
     
    antonye, Sep 8, 2006
    #3
  4. rob2

    Cane Guest

    Lay the bike down on it's side. Job done.
     
    Cane, Sep 8, 2006
    #4
  5. rob2 wrote
    <*sigh*>

    The bitch drives the van and you ride the bike.
     
    steve auvache, Sep 8, 2006
    #5
  6. Is it worth strapping the front brake lever too?

    Si
     
    Mungo \Two Sheds\ Toadfoot, Sep 8, 2006
    #6
  7. rob2

    Pip Guest

    Not IME, no.
     
    Pip, Sep 8, 2006
    #7
  8. rob2

    Domenec Guest

    It is when the bike is on a trailer with the front wheel being heavily
    charged so that there is friction between the wheel and the floor.
     
    Domenec, Sep 8, 2006
    #8
  9. rob2

    rob2 Guest

    I can visualise how that'll work out, thankyou.
    Don't see many people pivoting bikes on a sidestand, I assume
    I can practice this once in the road. Might have a go now for fun.
     
    rob2, Sep 8, 2006
    #9
  10. rob2

    Kevin Seal Guest

    Ask the bastards that nicked mine....
     
    Kevin Seal, Sep 8, 2006
    #10
  11. rob2

    Veggie Dave Guest

    Theoretically, anyway. In practice, on the other hand...

    --
    Veggie Dave
    UKRMHRC#2 BOTAFOF#08
    IQ 18 FILMS http://www.iq18films.com
    IQ 18 RADIO http://www.iq18films.co.uk
    Toxic Shock Syndrome Gets More Girls Than Me
     
    Veggie Dave, Sep 8, 2006
    #11
  12. rob2

    MattG Guest

    'snot that tricky. Might be a little tense, like, but it's not that
    hard.
     
    MattG, Sep 9, 2006
    #12
  13. rob2

    platypus Guest

    Lay it on its side and pile mattresses on top of it.
     
    platypus, Sep 9, 2006
    #13
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.