Paging Simes

I can't remember if I've already asked this.

Do you know any good spannawankas who would do a decent job of replacing
rear wheel bearings on an XJ40? Cheap is good, cash job is fine.

I'm near Hitchin, by the way.

--
Wicked Uncle Nigel - Manufacturer of the "Champion-105" range of rearsets
and Ducati Race Engineer.

WS* GHPOTHUF#24 APOSTLE#14 DLC#1 COFF#20 BOTAFOT#150 HYPO#0(KoTL) IbW#41
SBS#39 Enfield 500 Curry House Racer "The Basmati Rice Burner",
Honda GL1000K2 (On its hols) Kawasaki ZN1300 Voyager "Oh, Oh, It's so big"
Suzuki TS250 "The Africa Single" Yamaha GTS1000

 

My old spanner monkey in Markyate (near-ish Luton / Dunstable) is very
good with anything you throw at him. He's worked on all sorts of shite
old Wop stuff for me.

Bonus is that he's only £27.50 / hour, incl. VAT.

 

Using the patented Mavis Beacon "Hunt&Peck" Technique, SteveH

Okey-doke. Can you email me a phone # / name?

works. Ta.

--
Wicked Uncle Nigel - Manufacturer of the "Champion-105" range of rearsets
and Ducati Race Engineer.

WS* GHPOTHUF#24 APOSTLE#14 DLC#1 COFF#20 BOTAFOT#150 HYPO#0(KoTL) IbW#41
SBS#39 Enfield 500 Curry House Racer "The Basmati Rice Burner",
Honda GL1000K2 (On its hols) Kawasaki ZN1300 Voyager "Oh, Oh, It's so big"
Suzuki TS250 "The Africa Single" Yamaha GTS1000

 

Emailed.

 

Wicked said:

As the Bear says - Mark at Pool Bank Service Station in Nuneaton is the
top cove for this sort of stuff - ?20 per hour and he's a bit forgetful
about how long it takes - just did a full service on the TR7 - oils
(engine/gbox and diff) balance carbs and shim the tappets etc - for 50
quid all in.

 

Bear said:

I thin he enjoys the challenge of using his grand-dad's imperial
spanners again.