oversized bearings needed

Discussion in 'Motorbike Technical Discussion' started by aggie, Mar 21, 2006.

  1. aggie

    aggie Guest

    i have a 1938 UL (Harley Davidson flathead 80") and i need oversize
    connecting rod bearings. my motor came with an FL crankshaft assembly
    with a tapered pin and not the step pin that a stock UL crankshaft
    would use. i have not had any luck finding bearings that are half a
    thousandth oversize so far and if anyone has a source i can get em from
    or a set they will part with i would be very happy. Thanks
     
    aggie, Mar 21, 2006
    #1

    1. Advertisements

  2. aggie

    jimrichards1964 Guest

    ROLLER/TAPER/SHELLS? i have a bearing book that lists every bearing
    size, application made, if roller, deep groove, or taper roller, number
    from case please, not a harley man, but have seen rod set up, if needle
    rollers still may be asble to help with fractional sizes.
    jimmy
     
    jimrichards1964, Mar 22, 2006
    #2

    1. Advertisements

  3. aggie

    jimrichards1964 Guest

    try FAG AUSTRALIA PTY.LTD, thats where my books from, it also cross
    references
     
    jimrichards1964, Mar 22, 2006
    #3
  4. aggie

    aggie Guest

    thank you for the source...
     
    aggie, Mar 24, 2006
    #4

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. correct grease for swingarm bearings

  2. Installation of Shaft Seals and Bearings

  3. how do I set up tapered roller bearings?

  4. Ball bearings

  5. Using oversized piston rings

  6. ZXR750 L1 BEARINGS

  7. Oversized leathers?

  8. opinion needed on traffic violation needed!

Loading...