Got Fuel Gauge Wires out of 2002 Lowrider Gas Tank

Discussion in 'Motorbike Technical Discussion' started by Manjo, Aug 16, 2012.

  1. Manjo

    Manjo Guest

    My thaks for the two gas tank schematics. They were right on.

    Turns out the wires run down through a tube in the gas tank that keeps the wires from getting soked in gas.

    I pulled the wires out the bottom.

    I'm now trying to pull the two pins (12 V and grd) out of the AMP MULTITECH 2-pin connector using the directions in the Lowrider HD manual.

    I can't seem to free either pin using the manual's directions.

    Anyone done this? Is there a write-up or some guide as to how to free the two pins? I need to replace the old chewed-up wires with new ones.

    THanks,

    Manjo
     
    Manjo, Aug 16, 2012
    #1

    1. Advertisements

  2. Manjo

    Jeff Guest

    http://mael.rivoal.free.fr/Manuel Buell XB9R/sm_appb1.pdf

    Basically you stick a small tool into the connector alongside the terminal to
    depress the tang to unlock it and hold it there while pulling out the wire.
     
    Jeff, Aug 18, 2012
    #2

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. changing miles gauge to kilometers gauge on a 996

  2. Replacing the fuel tank on a 1996 Yamaha Seca II, is a 1992 tank compatible

  3. 2002 Savage gas tank problem

  4. Q- How To Install Simple Fuel Guage In Tank With Out One??

  5. Fuel coming out the gas cap

  6. Cleaning out a fuel tank

  7. HD 2002 Low Rider Fuel Gauge and Wiring Problem

  8. Got Fuel Gauge Wires out of 2002 Lowrider Gas Tank

Loading...