Fitting an aftermarket Radio

Plastic is on the bar, snacks at the other end...This may take awhile.

Being winter and all, I had this bright idea to install an
aftermarket radio in my previously radioless FLH. The compartment
where the dealer radio usually goes, is a little larger than this
radio. What can be used to make this radio fit> ? Are there some type
of sleeves that can be used to make this radio fit in the shell?

Thanks for the help. I got plenty of beer and a warm garage/basement
to work this out. I figure there should be some handy engineers out
there that can help me .

Thanks,
Speleo

In the Flatlands of Indiana

 

You have a very friendly and highly competent dealer nearby, right ?? Ask
them ??

Need to be careful to retain some ventilation. I would think simple spacers
would suffice.....rubber comes to mind.