Engine Sprocket Removal on Panhead

Discussion in 'Motorbike Technical Discussion' started by derch, Jun 14, 2009.

  1. derch

    derch Guest

    Hey all. A round for the house.
    I am attempting to remove my engine sprocket, primary chain, and
    clutch hub off my 48 Panhead. The engine sprocket won't budge. Is
    there enough room to attach a puller on the sprocket without damaging
    the primary chain or should I just heat the sprocket? Thanks all.
     
    derch, Jun 14, 2009
    #1

    1. Advertisements

  2. derch

    frijoli Guest

    I wouldn't heat it. Is this typically a press fit on the
    shaft, or is it tapered? Try PB Blaster penetrant. It works
    very well on stuck parts.

    Clay
     
    frijoli, Jun 14, 2009
    #2

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Loc-Tight on engine sprocket nut?

  2. Yamaha XT600 Front Sprocket Removal

  3. Engine removal - NTV 650

  4. That NTV 650 Engine Removal Problem I posted about

  5. Engine assembly and how an engine works.

  6. ZX10R Front Sprocket Removal

  7. Engine removal...pain?

Loading...