datatool evo alarm problem

Hi,


I've got a problem with my Evo alarm.


Late in november, my alarm handset battery got discharged, a­ couple
days later i replaced it, but now doesn't disarm the bike (w­hen the
circle button is pressed in the handset the red light seems ­ok) and
everytime i try to switch bike on, the alarm goes off.
Ended up leaving it, intending to deal with it now in januar­y.


During the last couple of months the bike battery got discha­rged. So
I
took it out of the bike and recharged it using optimiser III­. When i
plugged my battery back to the bike today, the alarm went of­f. This
happens as soon as the bike connectors got in touch with the­ battery.



The troubleshooting section ondatatool wasn't very clear.
Would this be a simple case of:
.. the handset being out of sync with the alarm
.. or the alarm being 'spiked'


How would i know which is which and how to resolve it? Can y­ou please
advise.


Best Regards and many thanks in advance
Ped

 

If your transmitter is out of alignment with the control unit you should
press both buttons for at least 5 seconds, release and try again. If the
red LED on the transmitter flashes at 1 per second replace the battery
when convenient as it's getting a bit weak. If it flashes at 5 per
second replace immediately with a type GP23A battery as it's about to
fail completely.

 

Helpful.

If the red LED on the transmitter flashes at 1 per second

I think he already knows that bit

My 2p would be to contact Datatool (not just read their website) and ask
them - or ring a motorcycle dealer and see if they'll give a of advice.