Bleed Hydrolic Clutch Prob? (CB 700 Honda Nighthawk)?

Discussion in 'Motorbike Technical Discussion' started by Dave, Nov 1, 2003.

  1. Dave

    Dave Guest

    I can't seem to get any pressure (ie. squirting fluid) at the clutch
    slave cylinder bleed nipple, when cracked - open, closed whatever >>
    Just a trickle if any, comes out when clutch lever being pumped, in, out
    whatever. Brake Fluid Resevoir Full. The reason for this: CLUTCH
    STOPPED WORKING after sitting for 9 months.
    Does this sound like a bad MASTER CYLINDER? How do you check it? Are
    rebuild rubber parts available?

    Thanks VERY Much I A, for any good advice. --- Dave
    Please reply here or email me by removing NO6SPAM from my addy above.
    ALL SPAM REPORTED!!
     
    Dave, Nov 1, 2003
    #1

    1. Advertisements

  2. Dave

    Jeremy Chavers Guest

    I had the same problem with the '85 CB650SC I picked up this summer, but it
    was because the hole in the bottom of the master cylinder was only letting
    down a very, very little amount of fluid due to gunk buildup. I cleaned it
    out with a needle, and the thing works great now....

    Jeremy
     
    Jeremy Chavers, Nov 1, 2003
    #2

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Help: Nighthawk 750 clutch mishap

  2. 1984 Honda Magna 700 hesitation problem

  3. Clutch Bleed Valve on 1994 Honda Shadow 1100

  4. Starter clutch problem/ Honda Nighthawk 750

  5. 1994 Honda Nighthawk Idle too High & Clutch Question

  6. Honda Honda Honda Honda

  7. Ducati 600ss brake bleed getting nowhere

  8. 700 nighthawk 1998 starter motor spins but doesn't engage to turn engine

Loading...